Seif5034
Regular Member
Firstly, I'm sorry if this is in the wrong section, but I didn't feel like it really fit any if the other areas. Mods feel free to move it if needed.
I have a S&W M&P9c. It is fairly new with (probably) less than 300 rds down the pipe. I have encountered a magazine issue with 2 of the 3 factory magazines so far. Once while firing at the range and once while OCing.
The issue is that the rounds about halfway down the magazine seem to jam themselves against the walls of the magazine. This makes it where I can fire 1 or 2 shots then I have a fail to feed. To clear the jam, I have been clearing the weapon, remove the magazine, remove the floor plate and then use a cleaning rod to dislodge the 2 rounds that are stuck.
I clean my weapons after every range trip. I stripped, cleaned and lubricated my pistol and magazines, but then it happened while holstered.
Any ideas?
I asked Smith and Wesson. They are sending me a return label
I have a S&W M&P9c. It is fairly new with (probably) less than 300 rds down the pipe. I have encountered a magazine issue with 2 of the 3 factory magazines so far. Once while firing at the range and once while OCing.
The issue is that the rounds about halfway down the magazine seem to jam themselves against the walls of the magazine. This makes it where I can fire 1 or 2 shots then I have a fail to feed. To clear the jam, I have been clearing the weapon, remove the magazine, remove the floor plate and then use a cleaning rod to dislodge the 2 rounds that are stuck.
I clean my weapons after every range trip. I stripped, cleaned and lubricated my pistol and magazines, but then it happened while holstered.
Any ideas?
I asked Smith and Wesson. They are sending me a return label