I did a few tests on my SW40VE. Trigger pull specs from Smith&Wesson say it's around 8 but in fact after testing is 10 lbs. I then did some research, found a way to drop it by a LOT. Ok, remove the slide so your holding nothing but the bottom half of the gun. There is a small pin at the back on the side of the gun, push that through and then pull on the metal peace you see sticking up. After you remove the trigger spring housing, you will see a large spring at the bottom with a smaller spring in the middle. At the bottom of the spring housing, remove that small pin and let the large spring fall out and replace the pin and put back together. Trigger pull on mine after testing is now 5 lbs. There are some videos out there that will show you how to do this but they are kinda hard to find so good luck. And "stungun", if you are going to try and insult someone, please make sure your a little over 12 years old before you do because it really makes you look that much more of a child. So please keep your childish mumbling to your self.