Nevada carrier
Regular Member
Follow these steps
1: Purchase a Blackhawk Quck disconnect kit (Additional holster optional if you don't like using the quick disconnect on your hip),
2: Purchase three 1/4" - 20x machine screws. be sure to get a length that will not protrude as far as to interfere with componates that may be inside the console. Purchase at least three 1/4" - 20 nuts, and at least three 1/4" washers
3: Remove your center console IAW the remove & replace procedure for your make and model of vehicle and determine the best placement for your quick disconnect female bracket, taking into consideration for clearance inside the console. there may be components that are very tightly placed in there.
4: Mark out the holes and drill them out with a 1/4" drill bit.
5: Bolt your quick disconnect female adapter to the console and replace it in your vehicle.
6: Attach the male quick disconnect adapter to your desired holster You may need to play with the configuration of the male adapter to achieve the desired ride angle.
This is what mine looks like:
1: Purchase a Blackhawk Quck disconnect kit (Additional holster optional if you don't like using the quick disconnect on your hip),
2: Purchase three 1/4" - 20x machine screws. be sure to get a length that will not protrude as far as to interfere with componates that may be inside the console. Purchase at least three 1/4" - 20 nuts, and at least three 1/4" washers
3: Remove your center console IAW the remove & replace procedure for your make and model of vehicle and determine the best placement for your quick disconnect female bracket, taking into consideration for clearance inside the console. there may be components that are very tightly placed in there.
4: Mark out the holes and drill them out with a 1/4" drill bit.
5: Bolt your quick disconnect female adapter to the console and replace it in your vehicle.
6: Attach the male quick disconnect adapter to your desired holster You may need to play with the configuration of the male adapter to achieve the desired ride angle.
This is what mine looks like: